dana.satriya

Buat yang mencari tutorial tentang DNS,, bisa mengunjungi situs ini..

12.49 -14.47 ..

A    ser_ims/COPYING
A    ser_ims/ut.c
A    ser_ims/onsend.h
A    ser_ims/atomic
A    ser_ims/atomic/atomic_arm.h
A    ser_ims/atomic/atomic_unknown.h
A    ser_ims/atomic/atomic_ppc.h
A    ser_ims/atomic/atomic_sparc64.h
A    ser_ims/atomic/atomic_alpha.h
A    ser_ims/atomic/atomic_x86.h
A    ser_ims/atomic/atomic_sparc.h
A    ser_ims/atomic/atomic_mips2.h
A    ser_ims/doxygen
A    ser_ims/doxygen/doxygen.config
A    ser_ims/doxygen/html
A    ser_ims/doxygen/img

over..

and

over..

again..

again..

again.. 

15.22

still hasn’t finished yet..

Weird,, today when executing pcscf,, i get this error : ./pcscf.sh: line 4: setkey: command not found ./pcscf.sh: line 5: setkey: command not found 0(17878) parse error (26,23-25): syntax error 0(17878) parse error (26,23-25): hostname expected 0(17878) parse error (26,25-26): Still no idea,, but I would prefer to reinstall everything, despite asking to the ml this is a fresh install, usually the core works just fine

but i’ll leave this machine like the way it is,, so that i can figure out what the problem is and post it again someday 

Router > en router # config terminal router (config) # hostname weaver router (config) # ip nat pool test 198.18.184.105 198.18.184.110 255.255.255.248 router (config) # ip nat inside source list 1 pool test overload router (config) # access-list 1 permit 192.168.100.16 0.0.0.15 router (config) # int s0/0 router (config-if) # ip nat outside router (config-if) # exit router (config-if) # int fa0/0 router (config-if) # ip nat inside router (config-if) # exit router # copy run start